6.2. Replacement of the pump of cooling liquid

 PERFORMANCE ORDER

We merge liquid from the engine cooling system (see Replacement of cooling liquid).
We disconnect the top and lower hoses of the thermostat (see Replacement of the thermostat).
We take off a generator belt (see Replacement of a belt of the drive of the generator).
We disconnect an adjusting level of the generator and we weaken its lower fastening (see Removal of the generator). We take away the generator to a mudguard.

Key "on 13" we turn off three bolts and we remove a pulley of the drive of the pump of cooling liquid.

Key "on 10" we turn off two nuts of fastening of a pipe of removal of liquid from a heater radiator, and also we weaken an inhaling of a nut of fastening of a pipe to a final collector (see Replacement of laying of inlet and final collectors).

Key "on 13" we turn off three bolts (one from above and two from below) fastenings of the pump to the block of cylinders...

... also we remove the pump of cooling liquid.

Between the pump and the block sealing laying is established.

Key "on 13" we turn off four nuts...

... also we uncover the pump assembled. Between a cover and the case sealing laying is established.

We assemble the pump with a new cover and new sealing laying. We install it on the engine in the return sequence.
It is possible to replace a cover of the pump and without removing its case from the engine. For this purpose we merge cooling liquid and we uncover only the pump as it is stated above, having left a pump housing on the block of cylinders. We establish a new cover in the return sequence.