We remove a head of the block of cylinders from the engine (see Replacement of laying of a head of the block of cylinders).
|
Key "on 10" we turn off two nuts of fastening of a branch pipe... |
|
... also we remove a branch pipe. |
|
Key "on 13" we turn off two nuts of fastening of a double branch pipe... |
|
... also we remove it from a block head. Between branch pipes and a head sealing laying is established. |
|
We enclose the improvised emphasis under the valve (a nut, but wooden whetstone is better). |
Rassukharivayem the valve (see Replacement of maslootrazhatelny caps of the mechanism of gas distribution).
|
We take out the valve from the directing plug. |
|
We apply on a plate of the valve pritirochny paste. |
|
We install the valve into place. We put on the device for grinding in a valve core. |
Pressing a plate of the valve to a saddle, we turn it serially in one, in other party.
|
If necessary for convenient access to extreme valves a key "on 13" we turn off two extreme hairpins, previously законтрив on them two nuts... |
|
We continue grinding in of the valve before emergence of an equal opaque rim on a saddle and a facet of a plate of the valve. |
Washout carefully, we install the valve into place, having replaced a maslootrazhatelny cap (see Replacement of maslootrazhatelny caps of the mechanism of gas distribution).
|
Head "on 12" we unscrew the plug... |
|
... also we remove it together with an adjusting bolt and a lock-nut. If necessary we replace them. |
|
By metal ruler it is checked the privalochny plane of a head of the block of cylinders. An admissible gap – 0,15 mm. |
|