3.24. Replacement of the pallet of a case

 PERFORMANCE ORDER

We remove an engine mudguard.
We merge oil from a case.
We merge liquid from the engine cooling system (see Replacement of cooling liquid).
We disconnect the top hose of a radiator (see Replacement of a radiator of the engine) and the lower hose of a radiator (see Replacement of the thermostat).

We turn off four nuts of fastening of a reception pipe to a final collector (see Replacement of details of system of release) and a key "on 13" we turn off a fastening bolt to a transmission arm.

We remove a reception pipe from hairpins of a collector and we lower it.

We turn off two top nuts of fastening of pillows of the engine (see Replacement of a pillow of a support of the engine).

Having enclosed wooden whetstone, we rest a jack against a coupling case (the engine it is possible to raise a waist).

We lift the engine, "helping" hairpins of pillows to leave the screw-driver openings of arms.

Head "on 10" we turn off nineteen bolts of fastening of the pallet of a case...

... also we remove it.

We establish the removed details into place in the return sequence. We recommend to replace laying of the pallet of a case with new, it is better with a pith crumb in rubber. We wrap bolts of fastening of the pallet gradually just as it was done when replacing laying of a head of the block of cylinders. We lower the engine, the screw-driver correcting hairpins of pillows in openings of arms of the engine. We fill in fresh engine oil in the engine.