3.18. Dismantling of a bent shaft

 PERFORMANCE ORDER

We take out a bent shaft from the block of cylinders (see Replacement of inserts of a bent shaft).

We pull together with a stripper a gear wheel from a bent shaft...

... also we remove it. It is possible to remove a gear wheel from a bent shaft and on the engine.

By the screw-driver it is hooked and we take out a segment spline from a groove.

We punch to small beards and, having hooked on a hook, we take out caps of oil channels of a bent shaft. We clean oil channels.
We wash out a bent shaft in kerosene or diesel fuel, we blow compressed air his internal cavities. We press new caps and we fuller everyone in three points a core.
We establish the removed spline and a gear wheel by means of the brass hammer.