We remove the transmission (see Replacement of the transmission) and coupling (see Replacement of a press disk assembled and the coupling switching off bearing).
|
|
We wrap into place one of bolts of fastening of the transmission. |
|
|
Leaning on it, an assembly shovel or the big screw-driver we hold a flywheel from a provorachivaniye. A key, and it is better a head "on 17" we turn off six bolts of fastening of a flywheel. |
|
|
... and a flywheel from a bent shaft. |
|
|
Key "on 10" we turn off two nuts of fastening of a guard of a case of coupling... |
|
|
... also we remove a guard. |
|
|
The screw-driver we hook a cuff... |
We press a new cuff, (see Replacement of a forward cuff of a bent shaft).
At the same time there is a risk to damage a seat of a cuff and a bent shaft therefore for replacement of a cuff the holder of a cuff, for what is better to remove...
|
|
... a key "on 10" we turn off two bolts of fastening of the pallet of a case to the holder of a cuff... |
|
|
... and six bolts of fastening of the holder of a cuff to the block of cylinders. |
|
|
By the screw-driver it is wrung out... |
|
|
... also we remove the holder. |
|
|
Between the holder and the block sealing laying is established. |
|
|
The screw-driver through a cut in the holder we beat out a cuff. |
On its place we press new, using an old cuff as a mandrel (see Replacement of a forward cuff of a bent shaft).
Installation of the holder is carried out in the return sequence. |