3.15. Replacement of a chain of the drive of the camshaft

 PERFORMANCE ORDER

For convenience we remove an engine radiator (see Replacement of a radiator of the engine).
We uncover heads of the block of cylinders (see Replacement of laying of a cover of a head of the block of cylinders).
We expose a camshaft gear wheel tag opposite to inflow of the case of bearings.
We take off a generator belt (see Replacement of a belt of the drive of the generator), a pulley of the pump of cooling liquid (see Replacement of the pump of cooling liquid).
We remove a natyazhitel of a chain of the drive of the camshaft (see Replacement of a natyazhitel of a chain of the drive of the camshaft).
Raskontrivayem also we turn off a bolt of fastening of an asterisk of the camshaft (see Replacement of the camshaft and levers of valves).
We remove a chain from a camshaft asterisk (see Replacement of laying of a head of the block of cylinders).
We remove a pulley of a bent shaft (see Replacement of a forward cuff of a bent shaft).

Key "on 10" we turn off three bolts of fastening of the pallet of a case to a cover.

... and also six bolts and three nuts of fastening of a cover of the drive of the camshaft to the block.

We uncover the engine.

Key "on 17" we turn off a bolt of fastening of a boot of a natyazhitel...

... also we take off a boot of a natyazhitel.

We unbend edge of a lock washer of a bolt of fastening of an asterisk of the drive of the oil pump...

... and a key "on 17" we turn off a bolt of fastening of an asterisk of the drive of the oil pump.

We remove a bolt together with washers.

We remove an asterisk.

Key "on 10" we turn away a restrictive finger of a chain and we remove it.

We remove a camshaft drive chain.

We remove an asterisk from a sock of a bent shaft (see Dismantling of a bent shaft).
We establish new details of the mechanism of the drive of the camshaft in the return sequence. Then we press on a boot of a natyazhitel a finger, pulling a chain.

We check simultaneous combination of tags on asterisks of a bent shaft and the block of cylinders (the chain is removed for descriptive reasons), and also tags on an asterisk of the camshaft and the case of bearings (see Adjustment of a gap between levers and cams of the camshaft).

We load a natyazhitel of a chain (see Replacement of a natyazhitel of a chain of the drive of the camshaft), we establish him on the former place and we pull them a chain.
We regulate an ignition advancing corner (see Adjustment of a corner of an advancing of ignition).