3.13. Replacement of a natyazhitel of a chain of the drive of the camshaft

 PERFORMANCE ORDER

Natyazhitel is established under a final branch pipe of a shirt of the cooling system.

Key "on 10" we turn off two nuts of fastening of a natyazhitel to a head of the block of cylinders.

We take out it...

... also we remove from it sealing laying.

Having clamped a natyazhitel in a vice, a key "on 13" we turn off the cap-type nut.

We check serviceability of a collet clip. At breakage of a pad of a clip we change a cap or a natyazhitel assembled.

Utaplivayem a plunger in the case of a natyazhitel against the stop and, holding it in such situation, we tighten the cap-type nut.

We install a natyazhitel in the block of cylinders (if necessary having replaced the damaged laying).

Having turned a bent shaft clockwise (that the chain stretched), we weaken an inhaling of the cap-type nut – "we discharge" a natyazhitel – and again we tighten a nut.