This work should be performed together.

By the crosswise screw-driver it is turned off three self-tapping screws...

... also we remove an overlay of a rack of a windshield.

Similarly we remove an overlay of the second rack.
We remove an overlay of a ceiling (see Replacement of an overlay of a ceiling).
We begin work with one of the top corners of glass.

We rest the Shlitsevy screw-driver against an internal edge of a sealant of glass and we fill it for an otbortovka. We fix a sealant, having inserted into the screw-driver formed a crack, but it is not deep that glass did not burst. We continue to fill with the second screw-driver a sealant for a roof otbortovka.

At first "we pass" the top part of glass, and then two side. Along with two parties we squeeze out glass from an aperture...

... also we remove it.

We remove a fringing and a sealant from glass.
Not to scratch new glass, we spread soft fabric on a cowl or a table. We stack on it glass.

We straighten and put on glass a sealant, since corners, and then on all perimeter.

We overturn glass and here and there we fill with the movements a fringing in a sealant.

The joint of a fringing is closed by the lock.

Again we overturn glass and we fill in a sealant section a cord 4-6 mm thick and slightly more than a perimeter of glass long. The ends of a cord we gush over in the middle of the lower edge of glass.

We put glass and we align it in a body aperture.
One person outside carefully presses the lower part of glass, and the second – in salon – begins to extend a cord from a sealant at first for one end, and then and for the second. Pressing a sealant fingers, we put it on an otbortovka more deeply. Thus "we pass" all lower part of glass.

We extend a cord on lateral faces of glass.

We establish overlays of a ceiling and racks of a roof as it should be, the return to removal.