We lift glass and we remove a door upholstery (see Replacement of an upholstery of a door).

From the face party of a door by the crosswise screw-driver it is turned off two screws of fastening of a back fillet...

... and, having slightly lowered, we bring a uvula out of a groove and we remove it aside.

The Shlitsevy screw-driver or flat-nose pliers we disconnect draft of the button of switching off of the lock.

The lock can be removed also with draft, having unscrewed the button of switching off of the lock (see Replacement of an upholstery of a door).

We disconnect draft of the switch of the lock of the external handle of a door.

Key "on 8" we turn off a nut of fastening of a forward fillet, we remove a plastic apron and, lowering a fillet, we bring him out of gearing from a resistant frame of rotary glass.

We take out a forward fillet from a door.

By the crosswise screw-driver it is turned off two screws of fastening of the internal handle of a door...

... and utaplivay the handle in a door.

By the crosswise screw-driver it is turned off three screws of fastening of the lock...

... also we take out it from a door together with draft and the internal handle.

Having noted a felt-tip pen the provision of a clamp on a rack, a key "on 10" we turn off three bolts of fastening...

... also we remove from a rack a door clamp together with adjusting laying. (We keep them at installation of a new clamp).

We grease the new lock with Litol-24 lubricant or technical vaseline, we connect to it draft with the handle and we install on the car as it should be, the return to removal. We establish a clamp. If necessary, having weakened an inhaling of screws of a clamp, we move it on a rack within cuts under screws. We try to obtain accurate operation of the lock. If there are no remarks to operation of the lock, collect a door.