5ab14532

14.7. Removal and installation of a steering shaft

 PERFORMANCE ORDER

We disconnect the minus plug of the rechargeable battery. We remove a steering wheel (see Removal and installation of a steering wheel), casings of an arm of fastening of a steering shaft, understeering switches, we disconnect the ignition switch socket (see Replacement of understeering switches).

From below the car a face key "on 13" we turn off a bolt of the coupling coupling on the lower end of a steering shaft. For descriptive reasons the vacuum amplifier of brakes is removed.

In salon under pedal knot we unbend a rug and thermal insulation...

... by the crosswise screw-driver it is turned off three screws self-tapping screws of fastening of consolidation of a steering shaft...

... also we shift it up a shaft.

Face key "on 10" we turn off two srezny bolts of fastening of an arm of a steering shaft.

If at bolts turnkey heads are broken, then a chisel we weaken an inhaling of the remained round heads and it is turned finally off their passatizham.

Face key "on 10" we turn off two nuts of fastening of an arm of a wheel...

... also we remove it together with a steering shaft.

Key "on 10" we weaken an inhaling of the coupling and, having turned the ignition key in situation "0" or "I" (to turn off blocking of a shaft), we take out a shaft from an arm.

On a shaft профрезерован a groove for a locking core of the anti-theft device.

The design of an arm allows to compensate not coaxiality of a shaft of a worm and a steering shaft in the vertical plane.

We establish a steering wheel and several times we turn it in both parties for self-installation of a shaft then we tighten nuts on an arm of a steering shaft.

ATTENTION! The shaft of steering is established on a shaft of a worm only in one situation.

Shlitsevy connection of a shaft of steering has dual hollows, and...

... on a shaft of a worm there are dual ledges.

In the same way the steering wheel connects to a steering shaft.