5ab14532

12.4. Replacement of spherical support

 PERFORMANCE ORDER

We hang out and remove a wheel.

Key "on 22" we turn off самоконтрящуюся a nut from a spherical finger of the top support.

By means of special adaptation (see Appendices) we press off a spherical finger from a rotary fist.

If there is no adaptation, then it is possible to vypressovat a spherical finger strong blows of the hammer to an eye of a rotary fist, at the same time wringing out from it the top lever an assembly shovel.

Two keys "on 13" we turn off three nuts of fastening of a spherical support to the top lever.

The spherical support with a protective cover fastens to the lever through a clamping plate.

The nut of the lower spherical support completely does not manage to be turned off at once as it rests against the lever of a rotary fist. Therefore a key "on 22" at first we turn off it on 3–4 turns.

We install adaptation and we press off a spherical finger from a rotary fist.

Completely we turn off самоконтрящуюся a nut and, raising a rotary fist, we remove it from a spherical finger.

Keys "on 13" we turn off three nuts of fastening of a spherical support to the lower lever. It fastens to it without clamping plate.

Before installation of new spherical support we will be convinced available of them lubricants and integrities of protective covers.
Completely to remove a rotary fist from levers of a forward suspension bracket, adaptation pressed off one spherical finger and insert instead of it a suitable emphasis. We press off the second spherical finger.
We establish spherical support in the return sequence.